Technical Structure Technical Specifications
| Fluid Admitted | Air, Vaccum | |
| Working Pressure | 0—1.0MPa 0—150psi | |
| Negative Pressure | -100Kpa -29.5 In Hg | |
| Working Temperature | 0—60°C 32～140°F | |
| Applicable Tube | PU / PA | |
| Body | Nickel Plated Brass and PBT | |
| O-ring | NBR | |
| Lock Claw | Stainless Steel(SUS) | |
Cautions in Application of Tube Joint
Thread Standard and Type
| BSPP, G -- 55° Parallel Pipe Thread | ||||||||
| G1/8 | G1/4 | G3/8 | G1/2 | |||||
 |
• PC-G Male Connector Most general style. In line connection of tubing to a female threaded port. External tightening with a flat wrench or socket wrench, internal adjustment with an Allen wrench. |
 |
• PL-G Male Elbow Most general style. Connection of tubing at a 90° angle to a female thread. External tightening with a flat wrench. |
 |
• PLL-G Extended Male Elbow Basically, it is used together with male elbow. Different point is that it is used for with fittings to avoid from interfering with each other by making thepiping two-level. |
 |
• PLF-G Female Elbow In line connection of tubing to a male threaded port. External tightening with a flat wrench. |
 |
• POC-G Hex. Male Connector In line connection of tubing to a female threaded port. Internal adjustment with an Allen wrench. |
 |
• PCF-G Female Connector In line connection of tubing to a male threaded port. External tightening with a flat wrench or socket wrench. |
 |
• PB-G Male Branch Tee Connection of two tubes at a 90° angle to a female thread. External tightening with a flat wrench. |
 |
• PBF-G Female Branch Tee Connection of two tubes at a 90° angle to a male thread. External tightening with a flat wrench. |
 |
• PD-G Male Run Tee Use to branch line in the same direction from female thread and in 90° direction. |
 |
• PDF-G Female Run Tee Use to branch line in the same direction from male thread and in 90° direction. |
 |
• PX-G Male Y Use to branch line in the same direction from female thread. |
 |
• PXF-G Female Y Use to branch line in the same direction from male thread. |
 |
• PKB-G Male Triple Branch Use to three-branch lines at right angles from female thread. |
 |
• PKD-G Male Triple Branch Reducer Use to three-branch lines at right angles from female thread. Different from PKB, connection of two diffenrent ΦD tubes. |
 |
• PH-G Male Banjo Connection of tubing at a 90° angle to a female threaded port. Tightened on the top of the fitting by use of a flat wrench or a socket wrench. |
 |
• PHF-G Female Banjo Use to branch line in the same direction or at the right angles from male or female thread. Multiplex connection possible. |
 |
• PMF-G Bulkhead Female Connector Use to connect male thead and tube through a panel. |
